How to Use

1. Take out the Cyber Clean® from its package. Roll it around in your hands for 10 seconds until your hands adjust to the pH of the Cyber Clean®

2. Just press and pull the dirt out of the surface you want to clean. Do not rub!

3. When dirt is on the surface of the mass of Cyber Clean®, fold the mass over the dirty part and the dirt will be trapped inside the compound.

4. The trapped dirt will never migrate to your hands or the next surface you clean with Cyber Clean®

5. You can use Cyber Clean® over and over again until it changes color.

6. Use the strengh(color) indicator on the package to know when you need a new Cyber Clean®: it is important to replace your Cyber Clean® once it changes color, as its absorption capacity is much lower and the pH level changes.

7. Cyber Clean® must be resealed inside of its airtight package, as there is alcohol and water in the compound, otherwise it will dry out.

8. We do not recommend using a discolored Cyber Clean® on USB ports, AV ports, monitor ports, outlets, or small cracks. Use only fresh Cyber Clean® on these areas.

9. Cyber Clean® is not a solvent and should not be used to remove stains. It only removes all the loose stuff.

10. Cyber Clean® does not remove oils and smudges off of Screens.